-
Speeds and feeds Desktop w/spindle
I watched a training session the other day and now I'm a little confused.
I'm trying to set up my tool database with my tools. I have the chip loads recommended for those tools, but this training said I should run the RPMs at the highest speed I have (18,000)and adjust the feeds. If I take a 1/4" end mill, (2 flute) at
18,000 rpms and 3ips the chip load is .005. Any thoughts?
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules