Page 2 of 2 FirstFirst 12
Results 11 to 15 of 15

Thread: Did I just waste $700?

  1. #11
    Join Date
    Dec 2000
    Location
    Thorp, WI
    Posts
    2,845

    Default

    If you go to the folder where all the post processors are and copy/paste the one(s) you want into the "my postp" folder, then those will be the only ones that show up in the drop box.
    Scott




  2. #12
    Join Date
    Oct 2009
    Location
    Little Elm Texas
    Posts
    75

    Default

    More good info! Thank you!
    Matt Raymond
    Custom Woodcraft, Inc.
    Little Elm, TX

  3. #13
    Join Date
    Oct 2009
    Location
    Little Elm Texas
    Posts
    75

    Default

    Just a quick note that I am up and running. With your help I didn’t give up. Not 100% sure I am using the correct SB file, but it works. Made a separate post about a weird noise when cutting v carve lettering.
    Matt Raymond
    Custom Woodcraft, Inc.
    Little Elm, TX

  4. #14
    Join Date
    Dec 2008
    Location
    Diamond Lake, WA
    Posts
    1,746

    Default

    Aspire and VCarve Pro, directly from Vectric, work fine on my 2009 PRSAlpha.
    Don
    Diamond Lake Custom Woodworks, LLC
    www.dlwoodworks.com
    ***********************************
    Life is not a journey to the grave with the intention of arriving safely in one pretty and well preserved piece; But to skid in broadside, thoroughly used up, worn out, bank accounts empty, credit cards maxed out, defiantly shouting "Geronimo"!

    If you make something idiot proof, all they do is create a better idiot.

  5. #15
    Join Date
    Mar 2004
    Location
    Lenox High School, Lenox MA
    Posts
    964

    Default

    I have a Shopbot PRT, with a 4g Board, circa 2006. Works great. This is the PP I use. I have Aspire but that should make any difference.

    Phil
    Attached Images Attached Images

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •