If you go to the folder where all the post processors are and copy/paste the one(s) you want into the "my postp" folder, then those will be the only ones that show up in the drop box.
Senior Member
If you go to the folder where all the post processors are and copy/paste the one(s) you want into the "my postp" folder, then those will be the only ones that show up in the drop box.
Scott
"It’s easier to fool everyone than it is to convince them they've been fooled" - Mark Twain
Member
More good info! Thank you!
Matt Raymond
Custom Woodcraft, Inc.
Little Elm, TX
Member
Just a quick note that I am up and running. With your help I didn’t give up. Not 100% sure I am using the correct SB file, but it works. Made a separate post about a weird noise when cutting v carve lettering.
Matt Raymond
Custom Woodcraft, Inc.
Little Elm, TX
Senior Member
Aspire and VCarve Pro, directly from Vectric, work fine on my 2009 PRSAlpha.
Don
Diamond Lake Custom Woodworks, LLC
www.dlwoodworks.com
***********************************
Life is not a journey to the grave with the intention of arriving safely in one pretty and well preserved piece; But to skid in broadside, thoroughly used up, worn out, bank accounts empty, credit cards maxed out, defiantly shouting "Geronimo"!
If you make something idiot proof, all they do is create a better idiot.
Senior Member
I have a Shopbot PRT, with a 4g Board, circa 2006. Works great. This is the PP I use. I have Aspire but that should make any difference.
Phil
Posting Permissions
Reply With Quote
