Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: Feeds and speeds webinar

  1. #11
    Join Date
    May 2014
    Location
    MA
    Posts
    529

    Default

    Hey Blaine, that's a great question! Here's the answer:

    Most recommendations of chipload get reduced when you cut deeper... So if you're cutting with a .25" bit usually the chipload recommendation is at a depth equal to the diameter of the bit, so in this case it would be .25". Let's say you wanted to use that same bit to cut deeper you'd have to reduce the chipload. That's reflected in the calculator but not explained well. I altered it so it shows the actual chipload and gives you a reminder to reduce it when you're cutting deeper than the diameter of the bit.

  2. #12
    Join Date
    Aug 2011
    Location
    Wilkesboro, NC
    Posts
    92

    Default

    Thank you for the clarification Eric. I appreciate it.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •