Results 1 to 2 of 2

Thread: X1-Axis Motor Vibrating on Intricate/Small movements

  1. #1
    Join Date
    May 2012
    Location
    Murrieta, CA
    Posts
    12

    Default X1-Axis Motor Vibrating on Intricate/Small movements

    I have a PRS Alpha 120x60 w/ ATC built in 2009, recently one of the X-Axis motors started vibrating pretty vigorously during small movements, I noticed it first during the C3 Homing routine. I ran a nested board of HDU signs after and the machine shutdown with a motor fault during cutting. I have tried reloading control box firmware, lubrication, tightening the gear, etc. Anyone have any ideas? Thanks.

    Kevin

  2. #2
    Join Date
    Oct 2000
    Location
    Willis Wharf, VA
    Posts
    1,764

    Default

    Hi Kevin,

    I suspect that one of your X-axis motors is not working. A preliminary way to check is to power up the tool and after a few minutes touch each motor...they should both be warm and a very similar temperature.

    The best thing to do is to get in touch with ShopBot support support@shopbottools.com when you're near the tool and they'll help work you through diagnosing the problem

    Bill

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •