While the other guys have covered your query from the Aspire side, it sounds like you could just make one design with the toolpaths for it and then create a master file (.sbp) that would call up the part file in 2d offset. Your master file would do the pre-positioning for each offset and then call up the part file. This saves having many toolpaths that do the same thing, but just in a different location, all saved into one very large long part file (or cutting and pasting as you have done). It also allows you to edit just one set of toolpaths if an edit is needed, rather than editing all 24.

If this is what you might be thinking of, I can give some examples. If I'm not following your question correctly, disregard the above.