Results 1 to 2 of 2

Thread: New spindle, control question

  1. #1
    Join Date
    Dec 2017
    Location
    Louisville, ky
    Posts
    15

    Default New spindle, control question

    Greetings All! I have an older 4x8 PRT. I just pulled the 3.5hp porter cable router off and put on a 10hp spindle. It's a beast! The question is this. Does anyone know of documentation or guides illustrating how to wire up control for my spindle speed via VFD? I'm sure I can wire the shopbot controller to send commands to the vfd for on/off and speed control. I'm very technically fluent just need the schematics or any type of documentation. Thanks!

  2. #2
    Join Date
    Dec 2000
    Location
    Thorp, WI
    Posts
    2,845

    Default

    Might want to specify what control box you have, what VFD, and the version of SB3 you're running.

    I have one of the USB spindle rpm controllers for sale if needed, it uses RS485 communication through SB3.
    Scott




Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •