Hello all!

I hope I'm posting this in the right section, this is my first time posting.

I had a question about the Shopbot.

I make crib boards and I use Aspire for making my tool paths. I have been running the file and when drilling the holes in the past the Shopbot runs smoothly from one hole to the next, but recently it has started pausing before every hole, then drills the hole.

I am using the same file as I always have, but it just started pausing for a moment before every hole which makes me think there is a setting on in the Shopbot software that has changed, has this happened to anyone else? How do you adjust this?

Thanks for any help!