Results 1 to 4 of 4

Thread: X and Z move

  1. #1
    Join Date
    Dec 2007
    Posts
    2,342

    Default X and Z move

    I have a 4G board that just started doing this. When I give an X command to move like plus 1 inch the Z will move up 1 inch and if I go neg 1 inch the Z will also go down 1 inch not sure how to solve this.

  2. #2
    Join Date
    Sep 2006
    Location
    Garland Tx
    Posts
    2,287

    Default

    Jerry…

    Any chance some cables got moved around?

    SG

  3. #3
    Join Date
    Dec 2007
    Posts
    2,342

    Default

    It was working fine 2 days ago today I noticed the Y dropped out and then when I got the Y back to working by replacing a fuse in the Gecko. The Z and Y work fine alone but the z moves along with the X when I try it

  4. #4
    Join Date
    Jan 2004
    Posts
    705

    Default

    check your software and see if they somehow got swapped there. If your cables are correct that is all I can think of.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •