Original Owner Since Fall of 2004
- 2004 96x48 PRT
- 5HP Colombo Spindle setup for 220V 30Amp Single Phase
- Delta Variable Frequency Drive already wired and connected to the Spindle
- Z zeroing plate
- X and Y prox switches
- E-Stop button and wiring
- Shopbot Controller (All 5 drivers are in working condition Indexer could be added)
- Serial Cable to connect PC to ShopBot Controller
- Hard Stops at both ends
- New Springs on Z axis to assure no down drift when powered down
2 Modifications
- Added 2" thick Bowling Alley Lane with threaded Inserts fasten mdf spoil board
- Added 3" x 3" x 24" long (80/20 aluminum) risers to Y axis gain Z height back.
- Removed original threaded feet and added vibration pads to help dampen any vibration
Collets (left to right - all used)
- 1/16" ER25 1 collet
- 1/4" ER25 1 collet
- 5/16" ER25 1 collet
- 3/8" ER25 3 collets
- 1/2" ER25 2 collets
- 5/8" ER25 1 collet
Additional Items
- 3 new pinions ( 2 for X and 1 for Y axis )
- 2 Vexta A6497-9412KTG for either the x or y axis
- 1 additional Shopbot Controller (All 5 drivers are in working condition Indexer could be added)
All in good working condition - Well Maintained
North Central Indiana
Buyer Responsible for Shipping - can help with loading
$10,000
donald9 at gmail.com - Text 260 - 5 six 8 - 333 zero