Page 2 of 2 FirstFirst 12
Results 11 to 14 of 14

Thread: Please explain signal processing steps

  1. #11
    Join Date
    Dec 2000
    Location
    Thorp, WI
    Posts
    2,792

    Default

    What are the temps in your shop? Just for fun, leave the control box door open and place a fan blowing directly into the box. Possibly a bad solder spot that opens up when warm or other component.
    Scott

    "It’s easier to fool everyone than it is to convince them they've been fooled" - Mark Twain





  2. #12
    Join Date
    Jun 2021
    Posts
    9

    Default

    It is late June in Texas, so it on the hot side. Too late for that test. Already pulled the boards. While I understand the suggestion, I have a hard time wrapping my head around a break being the culprit. The behavior seems more like a short that allows Z signals to get to the Y motor. But I'll never claim to be an electronics guy.

  3. #13
    Join Date
    Jun 2021
    Posts
    9

    Default

    Follow Up: Apparently there is a problem on the control board. Installed a new control board and the problem disappeared.

  4. #14
    Join Date
    Aug 2011
    Location
    Wilkesboro, NC
    Posts
    104

    Default

    Thanks for the update. Glad you got it sorted out

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •