Results 1 to 4 of 4

Thread: 10 ft table - rail length?

Hybrid View

  1. #1
    Join Date
    Jun 2018
    Location
    Pennsauken, NJ
    Posts
    15

    Question 10 ft table - rail length?

    Hi all,

    After nearly a year I've finally gotten electricians (needed several to get this done - looong story) I've finally gotten this dang machine (6' x 10' PRS-alpha with ATC) set up and connected to power. I have a question for anyone with a 10' table. Just how long are your rails? TBH, I think that mine should have been longer than what was provided but thought I'd ask the community. Mine are 144.25".

    Thanks!

    Rocco

  2. #2
    Join Date
    Aug 2011
    Location
    Wilkesboro, NC
    Posts
    108

    Default

    I had a Buddy so I can't say exactly, but I think it is the length of cut plus the width of the gantry. With the ATC, are the tool holders along the side or off the end? If they are off the end, there should be additional length for that

  3. #3
    Join Date
    Dec 2007
    Posts
    2,367

    Default

    That sounds about right.

  4. #4
    Join Date
    Dec 2011
    Location
    Piedmont, SD
    Posts
    723

    Default

    My PRS Alpha 9660 has 120", so I'd say your rails are about .25" too long.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •