10 ft table - rail length?

[Rocco.G]

Hi all,

After nearly a year I've finally gotten electricians (needed several to get this done - looong story) I've finally gotten this dang machine (6' x 10' PRS-alpha with ATC) set up and connected to power. I have a question for anyone with a 10' table. Just how long are your rails? TBH, I think that mine should have been longer than what was provided but thought I'd ask the community. Mine are 144.25".

Thanks!

Rocco

[Red F]

I had a Buddy so I can't say exactly, but I think it is the length of cut plus the width of the gantry. With the ATC, are the tool holders along the side or off the end? If they are off the end, there should be additional length for that

[jerry_stanek]

That sounds about right.

[jTr]

My PRS Alpha 9660 has 120", so I'd say your rails are about .25" too long.