indexer post processor

[Mike Windsor]

I'm trying to figure out what's going on with my indexer . first time using it . I created a rounding toolpath in aspire V11.5 and have the indexer set up on the X axis . Everything seems to be working but the b axis seems to be spinning instead of the moves that should be X axis traversing moves . I'm sure that it's just a matter of changing the post processer . The indexer motor is a vexta A7623-9412KTG driving the 6 inch indexer / I had to gues at the Vu values and am using 43 which seems to be close and smins it 360 degrees on MB 360 . Thanks

[rcnewcomb]

I saw you posted on the Vectric forum as well. Did you get this resolved?
https://forum.vectric.com/viewtopic....299505#p299505

[Mike Windsor]

Yes I did get it resolved . Shopbot support was great and sent me a link to post files for both X and Y axis within hours of my request . One of my issues was with the Optimized rounding toolpath gadget in Aspire 11.5 / The regular rounding gadget worked for me but the optimized one doesn't work for me yet