on a prs standard we are trying to change the 1 inch safe z so that we just clear so that we can still cut 3.5 deep with the cutter that we have. thanks Don Hunter
Member
safe z change for cutter clearace
on a prs standard we are trying to change the 1 inch safe z so that we just clear so that we can still cut 3.5 deep with the cutter that we have. thanks Don Hunter
Senior Member
Don,
Type VC in command line and under Safe Z pullup.
VERY important if Z-Zeroing to machine bed to add material thickness!!
sorry if I'm misunderstanding request.
scott
scott P.
2013 Desktop/spindle/VCP 11.5**
Maine
Super Moderator
Along with the Safe Z setting in the ShopBot software that Scott pointed out, if you use VCarve or Aspire there are some z-axis settings in the "Material Setup" section at the top of the Toolpath tab. These control things like how high it lifts between cuts while running a file.
Bill
Posting Permissions
Reply With Quote