Air drill error message

[cookie]

I updated to latest version of V carve pro and I toolpathed some shelf pin holes like I have before. Now when I saved the file the air drill pp wasn't there that I normally use. I tried the pp that came with v-carve and when I run the file I get a message undefined variables drill offset........... I installed the pp from an older version but still no luck. Help

[Gary Campbell]

Bruce...
What air drill do you have? PRT PRS?
Gary

[cookie]

Gary, I have a prt alpha.

[Gary Campbell]

Bruce...
I assume then that you are using the SB inch or mm drill postP?

You can get one here: http://www.shopbottools.com/drivers.htm (under partworks)

OR there are new versions being shipped with control software ver 3.6.1 They will install to the C:\SbParts folder.
Gary

[cookie]

Up and running. When I upgraded v-carve it didn't move all the settings like tool number over to the new version. Simple to fix hard to find or at least hard to find for me. Thanks