Is there any way to do "horizontal finishing" with Cut3d? In Rhino, it's the strategy that follows the profile at a fixed z-level, then drops down a specified amount and then repeats.
Gabe
Is there any way to do "horizontal finishing" with Cut3d? In Rhino, it's the strategy that follows the profile at a fixed z-level, then drops down a specified amount and then repeats.
Gabe
Hi Gabe,
This machining strategy is not in Cut3D / Partworks3D.
It is something we will look at developing in the future.
Tony
Thanks for the response
Gabe