Table Stops

[thewoodcrafter]

I have been wanting to do this for a long time.

[IMG]http://i251.photobucket.com/albums/g...r/StopDown.jpg[/IMG]

[IMG]http://i251.photobucket.com/albums/g...ter/StopUp.jpg[/IMG]

[IMG]http://i251.photobucket.com/albums/g...fter/Valve.jpg[/IMG]

Next project is a vacuum lift.

[cncb]

looks fantastic, where did you buy the air cylinders / solenoid manual switch?

[thewoodcrafter]

Thanks Brian.
Grainger or McMaster Car has all the parts.
The hard part was figuring out the length of the arm and where to drill the holes.
They work very good and I wish I had done this a year ago.

[wberminio]

Nice simple setup.
That's next on my list after I get my drill tweaked.

Erminio

[beacon14]

I'm drooling...