Results 1 to 2 of 2

Thread: Cutting threads on a Shopbot?

  1. #1
    Join Date
    Sep 2008
    Location
    Husky Design-Build, White GA
    Posts
    11

    Default Cutting threads on a Shopbot?

    Is this possible? I've seen a bit at McMaster's that seems to suggest so. I've got a project coming up that will use 3/4" PVC sheet to get 5" male threaded discs that need to go into mating female holes. Has anyone tried this before?

  2. #2
    Join Date
    Mar 2006
    Posts
    7,830

    Default

    http://www.talkshopbot.com/forum/mes...tml?1222218319

    we were just discussing this in this thread, good timimg.

Similar Threads

  1. Sticky threads
    By adrianm in forum About this Forum
    Replies: 3
    Last Post: 03-02-2015, 09:35 AM
  2. Trouble with internal threads
    By rww in forum Techniques for Cutting, Drilling, Machining
    Replies: 6
    Last Post: 09-24-2014, 10:27 AM
  3. Now we can cut threads
    By dan_nelson in forum ShopBotter Message Board
    Replies: 0
    Last Post: 06-29-2013, 10:28 AM
  4. Acme Threads
    By majohnson in forum Techniques for Cutting, Drilling, Machining
    Replies: 1
    Last Post: 10-15-2012, 11:37 PM
  5. Cutting threads
    By gugnheim in forum Indexer
    Replies: 8
    Last Post: 03-21-2010, 01:55 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •