Page 3 of 3 FirstFirst 123
Results 21 to 23 of 23

Thread: Are Perfect Circles Achievable? Any tips on cutting Polypropylene

  1. #21
    Join Date
    Oct 2000
    Location
    Atlanta GA
    Posts
    1,499

    Default

    I made a trammel gauge out of a piece of wood, a drill bit, and a pencil. Take a strip of scrap wood maybe 1" x 1" x 20" long. Drill a hole in one end just large enough to snugly stick a pencil into. Wrap some masking tape around the pencil if needed for a snug fit. Drill a hole in the other end with a 1/2" drill bit. Now jam the drill end of the bit into the hole, and chuck the shank of the 1/2" bit into the router. The pencil should be at the other end of the stick, pointing down towards the table.

    Of course the router is never turned on during this entire process. By making a larger diameter trammel you do not need micrometer accuracy. If you can adjust your Z axis to get the pencil tip to vary from the surface no more than 1/16" over a 36" diameter circle, that will equate to less than .002" with a 1" diameter router bit.

    The pencil and drill bit are still usable, so the only cost is the strip of scrap wood.

    You can make a decent surfacing file by drawing a rectangle a little larger than your table in PartWorks, and using a Pocketing toolpath with Raster selected instead of Offset. With a back and forth cutting action you may still see stripes even with almost perfect smoothness due to the opposing cut directions of the alternating stripes.

  2. #22
    Join Date
    Mar 2011
    Location
    ANAHEIM, CA
    Posts
    11

    Default Pvc

    Found some good info on PVC at http://www.iplasticsupply.com/materi...ride-sheet-rod. They have data sheets and whole bunch of stuff that might help.

  3. #23
    Join Date
    Mar 2004
    Location
    Delray Beach, FL
    Posts
    3,708

    Default

    A botter in Canada (Paco) wrote a surfacing program for hardwoods and surfacing your table that works well. Here's a link to it:

    http://pacosarea.blogspot.com/2007/0...t-routine.html

Similar Threads

  1. Circles not perfect
    By Shane in forum Techniques for Cutting, Drilling, Machining
    Replies: 4
    Last Post: 04-22-2014, 08:39 PM
  2. Problems cutting circles
    By 44henry in forum Archives2008
    Replies: 19
    Last Post: 05-14-2008, 05:44 PM
  3. Shakes cutting circles
    By seana in forum Archives2006
    Replies: 5
    Last Post: 12-27-2006, 07:45 PM
  4. Cutting Circles? Help please!
    By sawdust-and-noise@sympatico.ca in forum Archives2003
    Replies: 30
    Last Post: 07-31-2003, 01:23 PM
  5. Replies: 2
    Last Post: 01-25-2003, 12:29 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •