Page 3 of 3 FirstFirst 123
Results 21 to 23 of 23

Thread: Holding irregular material off the end of the table

  1. #21
    Join Date
    Jan 2004
    Location
    HAGGERTY WOODWORKING, SOUDERTON PA
    Posts
    245

    Default

    I didn't forget about you guys If I can an idea how many guys would be interested it would help me with setup times etc. leave a message here or shoot me an email
    John

  2. #22
    Join Date
    Jul 2008
    Posts
    299

    Default

    Hi I think I might me interested. Please e-mail me at frank134@hotmail.com if you go ahead with it. I would also like to know what the back plate is made out of?
    thank you
    frank

  3. #23
    Join Date
    Oct 2005
    Location
    Timberline, St .George
    Posts
    191

    Default air clamps

    found these on ebay,
    not sure if any of these might work
    was thinking of using a clamp system myself.
    paul

    http://compare.ebay.com/like/3504379...=263602_309572

Similar Threads

  1. BT 32 Table Material
    By Designer in forum ShopBot Buddy
    Replies: 11
    Last Post: 10-21-2015, 09:29 PM
  2. Has anyone made a vertical vise for holding material?
    By myxpykalix in forum ShopBotter Message Board
    Replies: 1
    Last Post: 10-21-2015, 02:14 PM
  3. Holding material while cutting 3D slices
    By rcnewcomb in forum Techniques for Cutting, Drilling, Machining
    Replies: 2
    Last Post: 06-24-2009, 08:05 AM
  4. Nylon screws for holding material down
    By hrshie3 in forum Archives2003
    Replies: 8
    Last Post: 05-08-2003, 08:59 PM
  5. Holding material ?
    By Support (Admin) in forum Archives thru 2002
    Replies: 6
    Last Post: 05-23-2001, 10:18 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •