I have a new customer that uses large radius pieces of plywood. The latest was 167" with a 6" wide plate,,making the inside radius 161"
My concern now is......how can I figure how to make the end cuts so the parts can be placed end to end to make a circle without field cutting the angle on the ends?
I was placing two radius' 6" apart and using a poly line slicing through the ends from a height of the radius at the center point on the plywood.
The angle was incorrect.
Second time I made the outer radius then offset inward 6" then I snapped a polyline to connect the parts. Not sure if this is right.
I could sure use some help on this....thanks for any help.
David