I have an opportunity to rebuild an exterior double door that a contractor botched. Six months ago, prior to the SB, I would have traced a template for top and middle rails and used a hand held router. I would obviously like to use the SB to cut these pieces from 10/4 Mahogany. How do I draw these curved parts so that they precisely fit into the contour of the arched door frame?
Also, you will notice that there is no door casing, which is also curved along the top. I believe the "extruder" feature is capable of producing such a piece using the profile of the straight casing. How is this done?
42245.jpg
42246.jpg
42247.jpg