Results 1 to 3 of 3

Thread: P-C 75182, How do I change bottom bearing?

  1. #1
    Join Date
    Dec 2006
    Location
    Dan Bloomer Designer/Craftsman, Waterville Maine
    Posts
    1

    Default P-C 75182, How do I change bottom bearing?

    On my P-C router body----I see that the collet unscrews from motor shaft. Any suggestions for holding the dang armature/shaft?

    Thanks in advance!!

  2. #2
    Join Date
    Jan 2004
    Location
    , South Jordan Utah
    Posts
    1,693

    Default

    There's some information in this thread that might help: http://www.talkshopbot.com/forum/sho...5245#POST25245

  3. #3
    Join Date
    Jul 2006
    Posts
    159

    Default

    Dan, Impact it off. There is no good way to hold an armature. When you put it back on as long as it is snug it will tighten itself. Like a tablesaw blade.

Similar Threads

  1. Porter Cable 75182 repair, or just trash it?
    By Ted D in forum Assembly & Maintenance
    Replies: 18
    Last Post: 03-10-2017, 11:26 AM
  2. V-carving with engraving bits: Bottom flat, bottom radius
    By Chuck Keysor in forum ShopBotter Message Board
    Replies: 5
    Last Post: 03-11-2016, 09:46 PM
  3. Router 75182
    By jimmya in forum ShopBotter Message Board
    Replies: 4
    Last Post: 02-02-2013, 02:39 PM
  4. bearing on rail squeal
    By plemon in forum Troubleshooting
    Replies: 0
    Last Post: 08-13-2010, 08:49 AM
  5. Vee Bearing Tracking
    By kaaboom_99 in forum Archives2006
    Replies: 13
    Last Post: 04-03-2006, 12:51 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •