All Axis are negative.

[khaos]

I want to reverse my table's coordinates the 0,0 is at the wrong end and the wrong side of the table. How can I flip this? I went to the VU and added a - to the x unit value that had no effect.

Also, Z axis goes negative pulling up from the table ....

Go slow Im new to the both the hardware and the software ...

:s

[Brady Watson]

Just type in VU & put a negative sign (-) in front of the until values. That should do it.

-B

[khaos]

Brady this was the solve.


Tanx.

[khaos]

And it was the solve again on the new computer.

I copied my sbparts folder over but I guess there was another location needed.

Thanks Brady

[khaos]

And the even newer computer

X & Y values only