In need of a Cribbage Board

[t_vandemark]

I've just been asked to make a cribbage board, but i am having a hard time finding a dxf of one. Is there anyone out there willing to share? Thanks alot.

[adrianm]

This thread from the Vectric forum might be of interest. It uses Aspire but the techniques for the actual board would work in PartWorks.

http://www.vectric.com/forum/viewtop...=29&t=4844

[myxpykalix]

go here:
http://www.cnczone.com/forums/showthread.php?t=19346
that is the first page of the thread and do a search because i have seen dozens in there. If you can't find them then go to the end of the thread here:
http://www.cnczone.com/forums/showth...6&page=425
then ask for one. You usually get a reply within an hour...

[t_vandemark]

Thanks alot Jack and Adrian i found one and just finished cutting it. I scaled it up so 0.25" pegs would fit in the holes that way the elderly lady i made it for can see the board.