I just got my buddy up and running, attached the spoil board and made it flat using the tool. So for my first project, I decided to cut a pocket in which to inlay my logo which is just my two initials in script. I imported a jpg file into partworks and made a toolpath for the inlay pocket and then made a toolpath with the same file for the logo profile.
Next I cut the parts on the bot and everything went great except the logo doesn't fit in the pocket. It's close but no cigar. I'm sure I can play with it to get it right but I'm hoping there is a built in factor that I can use to make the two fit. Anyone know if there is a scaling feature or some kind of fudge factor for this in partworks? I am using a 1/32" spiral upcut bit for this part in case it matters.
By the way it was very fun and exciting finally getting the tool moving after having it sit in my shop for the last month while I worked up the courage to get started!!!