Cabinet parts pro

[mars]

Hi to all,
I'm looking for someone that is using CPP version 8.5.18 to make a test.

I am trying to make a wall cabinet that is 60 wide, x 36 high and 16 inches deep and the Nester is giving me a pop up dialog box saying: execution error 340, element in group control 3 doesn’t exist, sometime it's the control 2 or 1.

If I change the width to 49 or lower, the Nester open and all the dimensions are has they should be

I'm not asking to cut the parts, only to see if the Nester is going to open normally.
Thank you