Hi! I'm new, so do forgive if I've put this in the wrong place...
This might seem like a daft question (a search brought up very little, so I'm likely missing something, somewhere...), but how does one machine a piece of specifically-sized material on a very specific spot on the board?
My specific example: I have a 3.375" square block, which I'm trying to cut a 3.125" disc from. I set the material origin in Part Works at the lower left corner with no offset (and sized at 3.375), then moved the tool tip to that corner, centered ON the corner (or as close as I could, which seemed to be very close), but the part cut off center - probably because I was eyeballing it. So: is there a better way of registering parts? What is the preferred method? I'm learning this form an all-laser background, so I may simply have some bad habits to shake off, but if I need tight registration for machining on a specific piece, is there an "easy" way, or is it a trial & error process?