I’m using Aspire 3.5, I would like to round over the edge the same time the top cuts so I could use the same ball nose. Is there a way to do this? I’ve tried the Sculpting tool, but it doesn’t look even to me.
Capture.JPG
Thanks for Helping
Jimmy
I’m using Aspire 3.5, I would like to round over the edge the same time the top cuts so I could use the same ball nose. Is there a way to do this? I’ve tried the Sculpting tool, but it doesn’t look even to me.
Capture.JPG
Thanks for Helping
Jimmy
I’ve never been fired, but, I have been laid off when they were still hiring.
PRS Standard 48"x96" with PC Router and Aspire 9.008, Cabinet Parts Pro
www.cncsignshop.com
cncsignshop@nc.rr.com
919-802-7477