I have a 3d probe.
no clue how to use it yet . only watched a few videos.
a guy wants me to route out a board so that he can display items he sells. they are hard to describe or put a name to. but they are roughly like a screw driver or chisel handle . sort of a elliptical cross section and curving all directions.
he wants me to carve out the board so that this item can sit in half way

assuming the probe works I should be ok to get the file.

problem is that the videos show using aspire to model it.
can I use v carve to create the cutting files and adjust anything.

also I need a cut out the same as the part (or the opposite of it) so that the part fits in.

any advise or suggestions
thanks alan