The urn is made from black walnut, with box joints cut on the table saw. I raised the panels for the lid, and bottom on the router table.
The engraving/cross were done on the shopbot, and drawn in V-Carve.
Finish is spray poly from a rattle can.
The cross was done with 3 separate tool paths. The cross itself was carved with a 60 degree B bit, prism tool path. Then the recess was out lined with a 60 degree v-bit, on a v- carve path. The pocket was cut with a .25 endmill, pocketing toolpath set to raster with the grain.
The name is partially obscured for the privacy of the family.
Left the photography to a professional for this one.
Last edited by michael_schwartz; 05-25-2010 at 07:55 PM.
Michael Schwartz - Waitsfield VT
Shopbot prs standard 48x96. Aspire. SB Link.