Used the genset to charge batteries today so I ran this file (thx viktor) for another local shop...
24.75 x 24.75 x .44 deep each side of a 1.375 thick alder panel.
on a...vintage pr machine, 6IPS XY,3IPS Z
did not miss a.....step
Used the genset to charge batteries today so I ran this file (thx viktor) for another local shop...
24.75 x 24.75 x .44 deep each side of a 1.375 thick alder panel.
on a...vintage pr machine, 6IPS XY,3IPS Z
did not miss a.....step
Last edited by gc3; 10-17-2010 at 11:18 PM.
Vector Studio 22
awesome looking piece Gene hope I can get this good one day steve
Spendid work, as always.
Great Job! I need to try out some 3d like this
upper panel - client loves it but a bit busy for me...
Vector Studio 22
another excellent piece of work. Do you experience issues with your wood curling up because you carve so much out of it?
Gene,
Great job - I agree, a bit busy for me, too. However, the client is always right...
Ron Sloan
Nice work- What are the dimensions and how long is it taking to carve?
26x42x.44 deep each side upper panel 6:50 hrs 26x26x.44 deep lower panel 3 hrs .25 ballnose 10% stepover
with the panel cut both sides it does not cup or warp....one side only and yes there will be movement.
Vector Studio 22
small question but I just want to clarify. When carvers say ball nose bit, is that the same bit that you would use if you wanted to make flutes, also called a core box bit?
Thanks Jason