I have been fooling with some different design cutting boards, that have become very easy to do now that I have a cnc router.
The first of course was one of the first things I cut, the circular board with tilted surface.
On the same lines, I did these up in Aspire, hope to cut this week. 16" square boards, one has the surface sloped from one side to the other. The other version has the slope from one corner to the opposite.
And finally, some friends of mine were in California, at a winery last year. The wine and cheese was served on these neat boards, where the board also acted as a holder for your wine glass, as well as a small cheese tray. So one can walk a round, eat, and not have to put your glass down.
I did this up last night on Aspire, and will cut it this week. The board is 12" by 9", 3/4" thick with the recessed portion 3/8" deep. There is a rounded recess for the glass 3" diameter which goes down to 1/4" and a 3/4" wide slot for the glass stem.
AJC