Originally Posted by
jdavinci
this is a project i made for a parade float, then later gave it to my dad as a gift. He volunteers as santa every year. It was quite a hit.
The pictures show just how simply it was made. It's end result far outweighed the amount of effort that went into it.
You might notice that all of the shapes are very basic vectric aspire extrusions, prisms and bulges.
The wood and the panels were cut on my shopbot. The arm rests were cut with a hotwire, then hand sculpted to make them round. Mostly made of osb and eps. With hardcoat and latex paint over it.