Any harm in using 1" ultralight MDF for a spoilboard? I typically use 18mm, but would like to go thicker, to lengthen the periods between replacement.
My vacuum consist of 4 motors mounted directly to the underside of the table.
Thanks
Any harm in using 1" ultralight MDF for a spoilboard? I typically use 18mm, but would like to go thicker, to lengthen the periods between replacement.
My vacuum consist of 4 motors mounted directly to the underside of the table.
Thanks
I use 1" no problems.
are you using it as a bleader board or spoil board ?
Using as spoilboard, it mounts directly to my plenum. (Not sure what a bleeder board is?)
bleeder board means you are using a vacuum and sucking air through it to hold down parts
Aspire Camp, Where the Creative come together !
https://www.facebook.com/pages/Aspir...92402730982116
www.mcgrewwoodwork.com
www.panelusion.com
www.carving3d.com
I am pulling air through it for my hold down...
Terminology !!
Aspire Camp, Where the Creative come together !
https://www.facebook.com/pages/Aspir...92402730982116
www.mcgrewwoodwork.com
www.panelusion.com
www.carving3d.com