2002 PR4896 accuracy issue looking for help!!!

[kentcustomcases]

Hey guys just bought a 2002 Pr4896 with some mileage on it and the machine will not cut accurately. It is all over the place. For example if I cut a piece 2" wide x 48" long in the Y direction part of the cut will be .125" off and part will be .0625" off. I am designing and making cut profiles in Aspire. I am plugging the cut profiles into ShopBot 3 I believe. Machine is constructed well and square. I have tried messing with the Unit Vales and still no change. Please help!!!! I am trying to use this machine to increase productivity of my business and it's just sitting there.

[dana_swift]

Something is clearly wrong, but it sounds like its more than you can manage.

You might consider getting Gary Campbell to come out and do a tune up on the machine. You would learn tons about it at the same time.

Get the machine in production and it should pay for his services..

Just a suggestion-

To pursue that, call the main SB number.

D

[jerry_stanek]

I would start by draw 4 crosses in a square at specific distances in Aspire and cut it on the line with a vcarve bit and run it on the on a piece of scape or just on the spoil board. measure each axis and see how far off you are. You can give me a call and I will try to get this resolved. Also It could be bit deflection you can check that by running the file in a climb cut.