While I have had my PRTAlpha with Spindle for a while, I am just getting started learning the ins and outs of various operations. I have searched the Forum (as well as others online) and would appreciate some sage advice, peanut gallery comments,guidance, help, etc., with my current project.
I am cutting a bookcase as a gift out of pre-finished 0.75" China Birch. I have .25" compression bits on order. This will be my first use of compression bits and have the following questions:
- Full depth cutting or multiple cuts at progressively deeper settings?
- Conventional or Climb Cutting?
- Speed recommendations for the 2.2HP spindle
- Compression bit or ?? for the rabbets and adjustable shelf holes?
Quality of cut is important. I know much could be done on the table saw, but I really want to use the Bot if for no other reason that to say I did
Thanks in advance.
Roy