Trying to import a stl file I got off the net into Aspire 4.5 with no luck.
I will open in Pro-E and 123D.
http://screencast.com/t/Mw2wgZFvXrYu
Trying to import a stl file I got off the net into Aspire 4.5 with no luck.
I will open in Pro-E and 123D.
http://screencast.com/t/Mw2wgZFvXrYu
Kyle Stapleton
River Falls Renaissance Academy
Math/Technology Education Teacher
PRS Alpha 96x60 2.2 hp spindle, Double Air drills, 6" indexer, Fein 5 zone vac table
Desktop w/spindle
Potter Pen
Aspire 8.5, Creo 3.0
That's an OpenGL error. Might be a video card driver issue? Can you import other STL's without problems?
Ron Sloan
Yes I can.
http://screencast.com/t/0yxJG2xWl
Here is were I got the file
http://www.thingiverse.com/thing:1274
Kyle Stapleton
River Falls Renaissance Academy
Math/Technology Education Teacher
PRS Alpha 96x60 2.2 hp spindle, Double Air drills, 6" indexer, Fein 5 zone vac table
Desktop w/spindle
Potter Pen
Aspire 8.5, Creo 3.0
That file imports fine into Aspire 4.5 for me.
As Ron says that error is usually caused by graphics card drivers.
The answers to a lot of questions can be found at http://www.shopbottools.com/ShopBotDocs/ or http://support.vectric.com/
What kind of card do I need?
Kyle Stapleton
River Falls Renaissance Academy
Math/Technology Education Teacher
PRS Alpha 96x60 2.2 hp spindle, Double Air drills, 6" indexer, Fein 5 zone vac table
Desktop w/spindle
Potter Pen
Aspire 8.5, Creo 3.0
Opened fine for me also.
It may just be a situation that you are running generic Microsoft drivers and need to update them to the manufacturer specific drivers for the graphics card or onboard graphics you have. Check the manufacturers site for them according to the model PC you have.
Scott
Will try tomorrow.
Thanks
Kyle Stapleton
River Falls Renaissance Academy
Math/Technology Education Teacher
PRS Alpha 96x60 2.2 hp spindle, Double Air drills, 6" indexer, Fein 5 zone vac table
Desktop w/spindle
Potter Pen
Aspire 8.5, Creo 3.0
Hi Kyle,
A few people updating to Aspire 4.5 via the patch seem to have ended up with an incorrectly updated opengl driver within Aspire.
There is an updated version of the patch now available - Aspire 4.510. Can you do 'Help - Check for Updates' again to update to the latest version. If the problem still persists after the update, please contact Vectric at support@vectric.com.
Thanks
Brian
Kyle,
Make sure that your job size is set large also. That model is very large in size if you dont reset the scale. Had that happen to me before on importing STL files
Scott, updated the driver still did not work.
Brian, tried to update Aspire and got this
http://screencast.com/t/nrTCU5x4FU4
hh, made my sheet size 96x48x5 and still did not work.
Anyone else have an idea?
Kyle Stapleton
River Falls Renaissance Academy
Math/Technology Education Teacher
PRS Alpha 96x60 2.2 hp spindle, Double Air drills, 6" indexer, Fein 5 zone vac table
Desktop w/spindle
Potter Pen
Aspire 8.5, Creo 3.0