Wanted: desktop with spindle

[rbarrow]

Looking for low use desktop/ spindle combo.

704-762-9066

[scottp55]

Roy, If it doesn't have the 5.5" Z conversion kit, make sure to double check the price/availability with Shopbot. 4" Z was fine, but 5.5" allows a lot more projects.
Maybe check Version of VCP as well, as 8 was a MAJOR upgrade with 8.5 and the 3D abilities.
Good luck,
scott

[rbarrow]

Roy, If it doesn't have the 5.5" Z conversion kit, make sure to double check the price/availability with Shopbot. 4" Z was fine, but 5.5" allows a lot more projects.
Maybe check Version of VCP as well, as 8 was a MAJOR upgrade with 8.5 and the 3D abilities.
Good luck,
scott

Much appreciate the advice! And...I will definitely now be aware of the fine points. I have a PRT that I have had for MANY years that we use for most projects but I am looking at trying to cut some small aluminum molds. The PRT can do it but don't want to tie up that machine for the 2.5d stuff.

Thank you!
Roy

[scottp55]

You'll like the Desktop.....working on a round(bark is tight) now that was impossible to keep flat, and VCarving a cardinal (bird) in the center, and cheating Z down by .001" at a time to get the tailfeathers, without making the eyeball disappear with a 60 engraving, and it's cutting Exactly what I'm telling it
TIGHT machine in all axis.

[rbarrow]

You'll like the Desktop.....working on a round(bark is tight) now that was impossible to keep flat, and VCarving a cardinal (bird) in the center, and cheating Z down by .001" at a time to get the tailfeathers, without making the eyeball disappear with a 60 engraving, and it's cutting Exactly what I'm telling it
TIGHT machine in all axis.

Sounds great! Now lets hope I can find one <G>

[rbarrow]

Bump to top

[rbarrow]

Still looking for a desktop...

[3degreeskelvin]

I have one with little use, 5.5" z and spindle .. spindle actually unused. It came with the router and I bought the spindle upgrade kit for it just haven't installed it. Also has the mini enclosure.

http://www.talkshopbot.com/forum/sho...-Area&p=190879

I have been meaning to post a new thread with current photos etc.

[rbarrow]

I have one with little use, 5.5" z and spindle .. spindle actually unused. It came with the router and I bought the spindle upgrade kit for it just haven't installed it. Also has the mini enclosure.

www.talkshopbot.com/forum/showthread.php?22961-FS-Shopbot-Desktop-Los-Angeles-Area&p=190879

I have been meaning to post a new thread with current photos etc.

Photos available?