P-C 75182, How do I change bottom bearing?

[Dan Bloomer]

On my P-C router body----I see that the collet unscrews from motor shaft. Any suggestions for holding the dang armature/shaft?

Thanks in advance!!

[Mike Richards]

There's some information in this thread that might help: http://www.talkshopbot.com/forum/sho...5245#POST25245

[Ryan Slaback]

Dan, Impact it off. There is no good way to hold an armature. When you put it back on as long as it is snug it will tighten itself. Like a tablesaw blade.