I notice today that there is a deflexion of about 1/8" on my BT32 alu table. Is it possible to do something about it?
31815.jpg
I notice today that there is a deflexion of about 1/8" on my BT32 alu table. Is it possible to do something about it?
31815.jpg
Where is tis deflection, can you post a larger picture in order to see the whole setup
The deflexion is at the center of the table. I just measure the gap which is 1/4"
When I received the crate, two of the "L" brackets where broken. I will post a picture later.
Middle of the table
31818.jpg
Right side of the table on the y axis.
31821.jpg
zoom out a bit to give us an idea of what we're looking at
I have the same thing on my BT48. The table does sag in the center where the gear rack is mounted. It's supported along the sides by virtue of the guide rails but (on mine) has a 32" span that is unsupported. It's probably too much to expect a 1/2" 6061-T6 plate to stay flat by itself in that configuration.
Jim
Thanks to Mr.Bourget in S.C. for resolving the issue. I unbolt the table and put shims over the rack&pinion. It is now perfectly flat. My two emails at Shopbot support team remains unanswered.
Photo
31878.jpg