I run a scale factor of 2.5 for V-carving and 4.3 for 3D work. YMMV
I run a scale factor of 2.5 for V-carving and 4.3 for 3D work. YMMV
- Randall Newcomb
10 fingers in, 10 fingers out
another good day in the shop
Wow... old threads don't die they just rise from the dead!
Don't know if you realized it...
This thread was started on 12-17-2006 and on 2-14-2007 faded away.
Then about 2 years and 3 months later another post.
Then about 11 months after that it comes alive again!
Still relevant... appreciate the knowledge.
Just found it interesting.