Senior Member
Good to hear! All because someone couldn't see the errant ":" in the MTC file and take the easy route of "it doesn't work on the Max".
6+ weeks * ??/hr vs knowing what the problem was after your first post.....I'll take the balance $$$ (not from you)!
Scott
Member
I do appreciate you helping me out here, you stepped in when no one else would.Originally Posted by srwtlc
Good to hear! All because someone couldn't see the errant ":" in the MTC file and take the easy route of "it doesn't work on the Max".
6+ weeks * ??/hr vs knowing what the problem was after your first post.....I'll take the balance $$$ (not from you)!
I created a test part that had several different tools and it ran fine as far as the tool changes go. The B value did do some strange things, but I do not think it has anything to do with the MTC issue.
I will start another thread for that.
I live 20 minutes from SB headquarters, if you are ever in the area, please look me up...dinner is on me.
Regards, Bob
Posting Permissions
Reply With Quote