Results 1 to 2 of 2

Thread: ShopBot Link 1-0-20 Update

  1. #1
    garyc Guest

    Default ShopBot Link 1-0-20 Update

    From the Thermwood website: http://www.thermwood.com/updates_shopbot_link.htm


    Items included in this update

    •Trimming routine for the pin area to square the sheet not cutting enough for full sheet flips with certain tool diameters and trim values. (FIXED)
    •Depth not correct for chain cuts from max penetration operations. (FIXED)
    •Holes that come close to touching from both sides of the part getting cut through when going to the Load screen and back in metric. (FIXED)
    •Flip operations not printing or graphically displaying properly when full sheet flips are used. (FIXED)
    •Dovetail construction failing with certain tool diameters and tabbing. (FIXED)
    •Failure to cut dados without warning occuring when select tool tolerance is set too large resulting in tool not being able to fit. (FIXED)
    •Part not getting perimeter cut all the way through when the perimeter has arcs and is not a double pass part. (FIXED)

  2. #2
    Join Date
    Dec 2008
    Location
    Diamond Lake, WA
    Posts
    1,746

    Default

    Yeah!!!!!!
    Don
    Diamond Lake Custom Woodworks, LLC
    www.dlwoodworks.com
    ***********************************
    Life is not a journey to the grave with the intention of arriving safely in one pretty and well preserved piece; But to skid in broadside, thoroughly used up, worn out, bank accounts empty, credit cards maxed out, defiantly shouting "Geronimo"!

    If you make something idiot proof, all they do is create a better idiot.

Similar Threads

  1. Update shopbot control computer with VCarve Pro Shopbot edition
    By Greybarn in forum ShopBotter Message Board
    Replies: 6
    Last Post: 11-16-2016, 11:55 AM
  2. did I update my shopbot with wrong machine
    By gillian in forum Troubleshooting
    Replies: 1
    Last Post: 10-29-2013, 08:25 PM
  3. ShopBot In Control Remote Software update
    By Coogara in forum ShopBotter Message Board
    Replies: 3
    Last Post: 05-03-2013, 10:29 AM
  4. Try out the Shopbot Link
    By benchmark in forum Cabinetry and eCabinet/ShopBot Link
    Replies: 0
    Last Post: 01-12-2010, 04:02 PM
  5. Update to Extruder in ShopBot Labs
    By bill.young in forum Archives2008
    Replies: 0
    Last Post: 11-20-2008, 07:50 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •