I am about to build a substantial project and have been asked to fabricate it in extira. Have sampled a few pieces and except for the fuzz after routing it seems OK to me. Now it comes down to finishing and confidence in the product/process. I can't afford a finish or material failure here in our Chicago weather so I hope someone can throw in their comments. I have read a few posts which indicate major finish failures and extira's specifications so perhaps those failures were due to insufficient surface prep or in adequate/incompatible materials? I would appreciate input from Anyone who has a known good experience or process to cut, sand, prime, finish or anyone who has used a recommended process and found out it failed and the reasons why.
THANKS