I need to cut angled slots into 1/2" plywood. Is this possible with the ShopBot?
I thought about making a jig with a flat top holding an angled workpiece. Is that the correct solution? My angle is 15% off horizontal.
I need to cut angled slots into 1/2" plywood. Is this possible with the ShopBot?
I thought about making a jig with a flat top holding an angled workpiece. Is that the correct solution? My angle is 15% off horizontal.
As a matter of fact:
http://www.talkshopbot.com/forum/sho...sing-angle-jig
Magnificent! Thanks.
Adding a flat top to my jig actually would mean I'd need a very long bit. I see this guy managed to cut straight into the workpiece. I'll just have to experiment carefully with pass depth.
Dear Bartharris
Have I missed something? Could you not use a 'fluting' toolpath? similar to the attached!
We use 'slim ones' for hiding the heads of pocket screws.
Sincerely and in good faith
Martin Reid
Pocket 01.jpg
Pocket 02.jpg