Hi Brady,
New fuse in today but still stumped and cannot move the gantry. Have checked the 24V and 5V DC output and it is good.
There is power at the wiring connectors on the front of the stepper dtivers but no led lights on any of them. See attached pic.
Another issue is that when we start the machine up and hit the reset button all is good. if we go to move the gantry it simply displays the error message and won't move. Interestingly, if I depress the master e-stop button, then release it, and press reset, the machine will not reset and the Reset Stop/Driver message remains in the red control box. I have checked all wiring in the stops from the switch to the board and there is continuity on all. Could be related but I'm not sure?
Any ideas?
Andrew