- Upgrading a PR (7 replies)
- G code from MasterCAM (0 replies)
- Any problems with this? (11 replies)
- Has anybody designed / fabricated a better dust skirt? (1 replies)
- Stopping router - un-attended (27 replies)
- V guide cam followers (1 replies)
- Modifying a Shopbot PR machine (0 replies)
- Acme Screws for X/Y/Z (2 replies)
- Vericle shopbot (2 replies)
- Mach 2 On a Shopbot (12 replies)
- Adding Mass to SB table (4 replies)
- Dovetailing the end of a table top (2 replies)
- Portable PR96 (2 replies)
- Cutting 7/8 Red Oak (4 replies)
- Airbrush on ShopBot?? (10 replies)
- Using a Colombo 10 hp spindle (3 replies)
- Virtual Leveler (71 replies)
- Simple vacuum jig(s).... (51 replies)