- Hershey Fonts, outdated GITHUB link (2 replies)
- Blast from the past (1 replies)
- Is CNC cheating? (25 replies)
- A new post on Medium with a project to make! (0 replies)
- These stools rock! (0 replies)
- 20+ years with ShopBot (11 replies)
- IBILD.com (21 replies)
- Make: Design for CNC,,, a short book review (0 replies)
- Using bits with bearing guides on CNC ? (6 replies)
- 5 axis dust control (0 replies)
- New Shopbot Users Group on Facebook (4 replies)
- Handibot G+ group (0 replies)
- Website and Social Media (0 replies)
- Finally getting this Facebook thing going... (22 replies)
- wix.com (9 replies)
- grits for sanding after a .25" ball nose finish pass (0 replies)
- Sanding complex contoured shapes? Arbortech Contour Sander? (7 replies)
- makecnc.com (0 replies)
- Playshop (11 replies)
- CNCKing.com (13 replies)
- Another upgrade, eStore.HabitatForBats.org (2 replies)
- new website is up (7 replies)
- Facebook Business page (18 replies)
- Easy, cheap and effective software (9 replies)
- Websites (92 replies)
- Blog Sites (40 replies)